The natural, shiny, water-displacing preservative for engines, housing parts, rubber hoses and assemblies on cars, commercial vehicles, etc. with a pleasant fragrance. The treated parts regain their shiny appearance. Due to the complete drying (no lubricating film), dirt binding is prevented. Due to the very good creeping effect and the permanently elastic protective film, the aggregates are protected against corrosion and environmental influences. Suitable for use on dry and wet surfaces. Temperature resistant up to 250°C. With Daimler approval.
Areas of application
Engines, housing parts, rubber hoses and assemblies on cars, commercial vehicles, etc.
Recommendation for use
Spray a thin layer evenly onto the pre-cleaned, wet or dry surfaces using a spray bottle or, ideally, Cyclone and then allow to dry.
Warnings
Check suitability and compatibility before use. Do not apply to surfaces where smoothness is undesirable.NoteThis product information is intended and can only provide non-binding advice. No liability on our part can be derived from it. Please check whether the product is suitable for your application. We are at your disposal for advice.
Warnings according to CLP regulation
Signal words: Danger Hazard statements:-H315: Causes skin irritation
-H319: Causes severe eye irritation.
Precautionary statements:
-P101: If medical advice is needed, have container or label at hand. P102-Do not get into the hands of children.
-P280: Wear protective gloves/protective clothing/eye protection.
-P305+P351+P338-BEFORE CONTACT WITH EYES: Rinse cautiously with water for several minutes. Remove contact lenses if possible. Continue to rinse.
-P337+P313-If eye irritation persists: Get medical advice/attention.
